![]() It is not intended to replace safe practices or careful handling of your RC power system, vehicle, and transmitter.Edge Arm Lock is only operational if you have successfully configured the Edge ESC using Castle Link software.Edge Arm Lock requires that the AUX LINE of the Edge ESC receives a voltage between 1.8V and 8.4V to arm. *The ARM LOCK KEY feature should be used as an extra safety measure NOT to replace general safety precautions.Įdge Arm Lock mode is intended as a secondary safety device. ESC must receive low throttle signal to arm and run. Key removed and power to socket = ARM UNLOCKED. If the key is placed in the socket or the arm lock socket loses power, the ESC will go into a locked state - even if it is running. A properly programmed and wired Edge will be incapable of arming when the key is in the socket. Key in socket OR disconnected wire in socket harness = ARM LOCKED. Connect the black/red wire to any servo wire with a Y-harness or to any empty channel on the receiver. Do not overtighten rear nut against wiring this can prevent proper operation.Ĭonnect the black/red/white wire to the Aux Line (white wire) on an Edge ESC. ![]() The socket may be installed through a panel or secured inside a fuselage. This setting can be found on the “OTHER” tab in the Castle Link software. You may continue to shop or immediately check out.īefore completing any of the following steps, make sure that the Edge ESC’s AUX LINE mode is set to “Arm Lock Key”. YOU WILL HAVE AN OPTION TO REMEMBER Y OUR PAYMENT INFORMATION FOR FUTURE PURCHASES. ONLY EXPEDITED OR INTERNATIONAL SHIPPING METHODS WILL BE CHARGED. NOTE: A VALID CREDIT CARD OR PAYPAL ACCOUNT MUST BE ENTERED TO PROCEED. After entering your coupon code press "APPLY COUPON" to receive your discount. The coupon code is valid for US POST only. Redeem your free Arm Lock Harness by entering a quantity of 1 and proceed to checkout where you will be prompted to enter a valid coupon code. If the key is inserted while the motor is running, the ESC will go into the ARM LOCKOUT state stopping the motor from running and preventing the ESC from arming. ![]() Once the key is removed, the ESC will arm when it receives the low throttle command on the traditional throttle line. ![]() When the key is fully seated into the socket, the controller will be incapable of arming. The Castle Creations Arm Lock Key Harness attaches to the AUX LINE and the receiver, and is designed to act as an extra safety measure while operating your RC Heli or Airplane*. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |